PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

Hi~


Original aegis~





I want to scratchbuild a round part that can fit the white pla-plate shape~


Press it slowly~~


Sand it after it fully cure~


After tat i recast the round part ( this is different from previous one~)

I recast it cause i dont have much pla-plate~ need to sav it for emergency use~


I cast the fin for detailing~


Both also mod using MG ver. ka feet.. i have decide to use that part on the left..
sigh~ pic a bit blur~


I use that sanding tool to sand 45 degree corner~~ just need to measure using eyes~

I sand the shape using the sanding tools i post on previous thread~




As you can see~ got lots of mistake there~ will repair it next time~


I use the extra epoxy putty.. roll on the table make it flat..
then it becomes~~~ putty plate~

If you have aegis~ then you will know that when it transform, that part need to shift down~ so i just use some joints to make this~







Comments are welcome~~

So..... kawan, this one for what ar? Compy?

This kit still not enough to challenge you guys in comp lar..
Not sure yet.. if mood nice.. then continue lor~