PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

Yo.. very stress at work.. so channel the stress into sanding power...

Here's the 3rd project on my desk.. pretty sharp kit and only a few pieces. Dont know how to mod it.. so just OOB

The 'problem' areas that need putty and sanding..




After sanding..




Ready to prime


no technique here, move along... nothing to see...

ggg Wrote:Another point to bring out is WIP.

But I dun see any around here. mostly is finish works not much techniques here???

yo max juz check with you on the area you put your putty...

Wat putty are you using? Looks kinda smooth there...

take out my Yukikaze and snap!!!! any theme you gonna do?

yeah!! mave is my favorite!!!
pitty my supersylph only snapfitted and sitting in the box....

Wah sexy kit... but very small also...

wingzero78 Wrote:yo max juz check with you on the area you put your putty...

Wat putty are you using? Looks kinda smooth there...

Using normal Tamiya Putty.
But dump half a tube of it into an empty surfacer bottle with about 1/2 filled with thinner as my 'ready' supply of putty.. lasted me a about 2 mths liao.. if find the texture a bit hard.. just add thinner to taste

Thanks man!!!

You said you added thinner...Wat thinner you used? Because I tried to used it twice (thinner plus putty both from Tamiya) mixed it together but i juz couldn't mix it till wat you acheive. The same happens when I used the Mr. White putty combo with Mr Color thinner.The end results is like wah lao eh "rice in water" effect...one piece one piece...Need to thin it with Extra Thin Cement then solve the prob...

Too bad I don't have a picture of it if not can show you.Maybe when I take a picture of it,then I post it here to show?Can?

I use nakamoto's thinner.. and previously use gunze thinner (dont know about the cheap nakamoto thinner)

Hmm.. not sure what went wrong for yours.. but I just add thinner and stir till evenly mixed... need more elbow grease??

I use Tamiya Grey putty mix with Gunze Thinner...

wingzero78 Wrote:You said you added thinner...Wat thinner you used? Because I tried to used it twice (thinner plus putty both from Tamiya) mixed it together but i juz couldn't mix it till wat you acheive. The same happens when I used the Mr. White putty combo with Mr Color thinner.The end results is like wah lao eh "rice in water" effect...one piece one piece...Need to thin it with Extra Thin Cement then solve the prob...

Winzero78 .. i think the reason you cannot mix them because you use Arcalic thinner (X20A) right ? try to use Ename thinner then you will mix it. Cuz the water base thinner can not mix putty. This was the mistake i did last time.... .. hope you can mix it..

oh ya.. you can even use Mr Color thinner to mix it as well.