PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

hi guys some new project i'm working on currently, the galbady.
i got this kit from nakamoto, it was quite a good buy only $4.
so i think i'll have a go at revamping this old kit and see what i can do with it
it's still quite rough at the moment more work to be done

cut the top part and some stuff off the face.. more work to be done on it


new hip joint mod , so the legs will be more posable


the joints are borrowed from tall geese

i'll keep my fingers crossed and hope they dont release a HGUC before i finish

I am looking forward to your WIP!! Old kit new style is ALWAYS ONE UP!!

hooarh! I'm definitely going to monitor this thread

Looks interesting already!

FWAH! Looks good man! Quick quick do it up and MG-ise it!

some updates again, modded the legs to be more flexible and to look slightly slimmer (planning on a lira rira custom unit )



total of four parts for the leg


back of the leg


cut out the skirting and added joints to each piece, still left the two front piece...run out of wave joints, must wait tomorrow go buy


put the leg onto the hip and abit of pose testing


the kit still looks quite rough , will putty the holes and areas once i finish most of the joint mods

You know the scene in Seed Destiny when Shinn carved up all the Earth Alliance ships and the  naval officers from Orb were like :-O?

I need one of those emoticons, like NOW!!!!

wow this mod is d@mn nice

yeowza!!!!.....
one of my fav titan MS.....
very cool mod on the legs.....!!!

..................

great mod bro. Keep it up!

more updates everything still looks very rough bec i haven sanded or trimed anything because i wanted to finish all the moving joint mods then start adding and adjusting the proportion


the skirting of the original kit was one whole piece like most NGs so i did some mods to the skirting, seperated all the pieces and added joints to each individual piece added poly caps to the blitz groin joint. the center portion is lengthen with epoxy putty but haven sand down to shape yet


sorry this pic quite blur, camera cant go macro and pic is taken at night. the ball joints is inserted into the styrene pipe


some waist mods done, ball joint added to the mid section and poly cap at the based


test fit