PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

ok my first car so see any mistake please kits ok ????

another thing just found out my elder spoil my dc so bo bian use H/P camera so please excuse lousy photo quality

1/24 tamiya GT-R

ok first off the photo etch i am using heed max advice

and look further than tamiya PE so i bought 2 sets



first off zing the rear seat put in leather sia



next the pe parts now using hobby design PE




cut off the pedal and drill out the air-con hole to put in the PE part



most important can i finish this ????? sure hope so my twins is looking

over my shoulder every day colour for this ride will be matt light gunmetal

the 1/60 gouf was sold so the zinging stopped so sorry never inform

ok stop now eyes needed to rest ok people kits away

today make carpet for my GT-R

here is the plain floor



apply white glue



apply flocking powder



and viola carpet sia



also strip the chrome off the wheel



since in the toilet i also clean up my z'gok conversion



that is all for today

pe part for the brake disc





bending the spoke



after some time and headache



after much more time and a mega headache the final product





1 down 3 more to go the day dun look bright for me

let with one problem how to cut out the brake disc form the clamp and

insert this

FWahh... nice leh!!! but hor put liao cannot see...

BUT




YOU KNOW ITS THERE!!!!!!!!!

yah also think about this but since buy already bo bian

take it as practice and experience

struggle struggle finally get these done



problem encounter how to merge these to up the zing factor



that all for now eyes dying going downstairs to look

at eye candy to do some eyeball excerise

Drill/cut out the disc brake, hollow out the centre part and put the disc brake to the PE ones.
Have fun dude!!

we have seen the hobby design zing zing zing disc brake..
it's enuf liao
use the tamiya pe to save all the fuzz

sori man.. feel rili bad for not help


i got the lazyman way.. remove the brake clamp fr the disc (disc sure gone liao)
then separate the clamp like how u slice bread, put the top part on the hobby design pe disc lor..

woah! not easy stuff...
Make it work!

Woah!!! Really really nice!! What an eye-opener, i didn't know got PE parts can do till like that!! I also really like the 'carpet' feel!

Sorry can't help much too, I can only think of cutting the brake clamps from the original part and stick on to the PE parts...

Good Luck!! Hope to see the finish product soon!!