PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

Sanding.. who loves sanding....

Anyway.. to make things easier to sand contours.. why not make your own curved sanding block

Here's what I did to sand the 4mm extension of the GM leg

Take a piece of eraser/rubber and cut to size.


Wrap with Sandpaper


Sand Away


I find that there is no need to use double sided tape to hold the sandpaper down because when you are sanding your 3 fingers are holding the top and the 2 sides.

Now.. to continue my sanding....

dash down to popular buy "rubber"(eraser)

Woahh.. good idea!!! :winks2ft: Me gonna try it out later.. heehee..

haha, thanks for sanding this idea max, anyway i think instead of the double sided tape, juz nail a stapler nail into it can liao hehe, now off to try it, hope i can find a eraser

good idea max ! keep your creative juice rolling

you can add a thick piece of acrylic or plastic to the back side too to sand flat surfaces

This is a great idea for sanding contours! thanx max!! :winks2ft:

BTW sidenote ah, try to get the "harder" erasers, not the soft soft type.

Ideally you should get the Staedtler(spelling) ones or the type used for erasing off pen marks(blue in colour) cos those are not as soft as the modern erasers.