PLAMO: Re-WiredWolf - Plastic Modelling, Share & Learn

I am using guncannon for woob competition..

These are my tools.. all can get from stationary or hardware shop..



My darkside..



Back to topic~ here come the guncannon..
Pic before detailing..



This is the way i scribe panel lines with needle..
and the screw driver is for drill hole,
the home-made pin vise for pricking hole..





Comments are welcome~ thanks~:em59:

Woah!!! Thanks for the tip on scribing! Will be useful for the members here to learn a trick or two

Drift's homemade scribing template! Good tip!

Drift, like I mentioned to you before, try getting the transparent plaplate. Thicker than normal photocopying transparencies, I think they are at least 0.1 or 0.2mm thick. Would be better if it was transparent, can gauge position of the lines a lot better.

But too bad dont know where can get the tranparent pla-plate now..

I am still trying to draw circle.. circle a bit hard leh..

Transparent pla plate? Get from any stationery shop selling bus card holders, the hard type. Or buy from Kinokuniya stationery department.

Great tips!! Nice room!!!

good tips... now i know what can i use for my transparent pla-plate liao...

I used to drill holes with those tiny negative screw drivers too, it works great for a while, until u realise that your fingers start to get really sore...

Got myself the acadamy pin vise recently and I wish I had bought it much earlier. May be u can give it a try

nice work on the template!!
never thought about doing that
for the minus signs... great tip!

Just finish the detailing on one leg today..



I try use silver marker pen to paint the small hole.. hm.. looks weird right~

Comments are welcome~~